ES720.1 - User’s Guide 9
ETAS Basic Safety Notices
2 Basic Safety Notices
This chapter contains information about the following topics:
• "General Safety In
formation" on page 9,
• "Requirements for Users and Duties for Operators" on page 9,
• "Intended Use" on page 9.
2.1 General Safety Information
Please observe the Product Safety Notices ("ETAS Safety Notice") and the follow-
ing safety notices to avoid health issues or damage to the device.
Carefully read the documentation (Product Safety Advice and this User's Guide)
that belongs to the product prior to the startup.
ETAS GmbH does not assume any liability for damages resulting from improper
handling, unintended use or non-observance of the safety precautions.
2.2 Requirements for Users and Duties for Operators
The product may be assembled, operated and maintained only if you have the
necessary qualification and experience for this product. Improper use or use by a
user without sufficient qualification can lead to damages or injuries to one's
health or damages to property.
General safety at work
The existing regulations for safety at work and accident prevention must be fol-
lowed. All applicable regulations and st
atutes regarding operation must be
strictly followed when using this product.
2.3 Intended Use
Application area of the product
This product was developed and approved for applications in the automotive
sector. The module is suitable for use in interiors, in the passenger cell or in the
trunk of vehicles. For use in other application areas, please contact your ETAS
contact partner.
At ambient temperatures between 55 °C and 7
0 °C, the module may be used
only at an operating facility with restricted access. The following must be
ensured at this operating facility:
1. Access to the operating facility:
– For maintenance personnel only, and
– For users only who have been informed about the access restriction to
the
operating facility and about all precautionary measures to be
observed
2. Securing the operating facility:
– Access to the operating facility is secured by means of a tool or lock
and key
or some other way and is monitored by the persons in charge
of the operating facility.
To Next Page
Loading...