12 Wireless TimeClock Configuration Guide
Main Menu
The Main Menu provides access to set up and schedule events, settings, and
link controllers. Press [Up], [Down], or [Enter] to wake up and navigate the
Main Menu screen.
To navigate the menu options, press [Up] or [Down] to scroll and press
[Enter] to make a selection. Press [Back] to cancel without saving. See Menu
Flow Examples on page26 for a selection of submenus and navigation.
Schedule an Event
1. Select Schedule Events from the Main Menu and press [Enter] to
modify the Event Number.
2. Press [Up] or [Down] to scroll the numbers, and press [Enter] to select.
3. Press [Down] to focus on Action and press [Enter] to modify.
4. Use [Up] or [Down] to scroll through the actions: Scene, OFF, ON to
Level, Mask, Temp Config, and None. See the following steps based
on your selection.
Define a Scene Action
Schedule Event
Event Number: 1
Action: Scene
Group Number: 4
Scene Number: 10
Recurrence Tuesday
When: Time of Day
Time: 12:00am
Sweep: Enabled
Sweep Duration: 12h00m
Next Event: None
1. Press [Enter] to select Scene as the event
Action.
2. Select a Group Number from 1 to 24, and
press [Enter] to select.
3. Select a Scene Number from 1 to 15, and
press [Enter] to select.
4. Select a type of day for Recurrence.
• None, Every day, Weekdays, Weekends,
or a day of the week. Select None if the
event is going to be used in a compound event. If not None, define
the setting for When and Time or Offset.
5. Select a reference time of day for When.
• Time of Day, or an astronomical setting (Before/After
Sunrise/Sunset).
6. Set a Time or an Offset, depending on the When option you selected.
• If Time of Day was selected, specify the Time in hours and
minutes 00h:00m (am or pm).
• If an astronomical setting was selected, specify the Offset hours
and minutes from the astronomical setting. For example, if
Before Sunset is selected, choose how long before sunset you
want the event to execute. The Next Time is calculated and
displayed in parentheses (##:## am).
7. Select disable or enable Sweep to reapply event settings, removing
any manual settings.
• Enable or Disable. If enabled, specify the Sweep Duration
0h00m, maximum 24h59m. See Sweep Interval on page19 to set
the interval.
To Next Page
Loading...
