ETC echoflex WTC - Define an OFF Action; Define an ON to Level Action

Wireless TimeClock Configuration Guide 13
8. Select Next Event and enter an Event Number from 1–50, if you want
to create a compound event.
Define an OFF Action
Schedule Event
Event Number: 2
Action: OFF
Group Number: 20
Recurrence Monday
When: Time of Day
Time: 12:00am
Sweep: Enabled
Sweep Duration: 2h00m
Next Event: 18
1. Press [Enter] to select OFF as the event
Action.
2. Select a Group Number from 1 to 24, and
press [Enter] to select.
3. Select a type of day for Recurrence.
• None, Every day, Weekdays, Weekends,
or a day of the week. Select None if the
event is going to be used in a compound
event. If not None, define the setting for When and Time or
Offset.
4. Select a reference time of day for When.
• Time of Day, or an astronomical setting (Before/After
Sunrise/Sunset).
5. Set a Time or an Offset, depending on the When option you selected.
• If Time of Day was selected, specify the Time in hours and
minutes 00h:00m (am or pm).
• If an astronomical setting was selected, specify the Offset hours
and minutes from the astronomical setting. For example, if
Before Sunset is selected, choose how long before sunset you
want the event to execute. The Next Time is calculated and
displayed in parentheses (##:## am).
6. Select disable or enable Sweep to reapply event settings, removing
any manual settings.
• Enable or Disable. If enabled, specify the Sweep Duration
0h00m, maximum 24h59m. See Sweep Interval on page19 to set
the interval.
7. Select Next Event and enter an Event Number from 1–50, if you want
to create a compound event.
Note: For scheduled OFF events, consider enabling Flick Warn. See
Flick Warn on page20.
Define an ON to Level Action
Schedule Event
Event Number: 3
Action: ON to Level
Group Number: 6
Level: 5%
Recurrence: Weekdays
When: Before Sunrise
Offset: 1h15m
Next Time: (7:58am)
Sweep: Disabled
Next Event: None
1. Press [Enter] to select ON to Level as the
event Action.
2. Select a Group Number from 1 to 24, and
press [Enter] to select.
3. Select a Level from 0% to 100%, and press
[Enter] to select.
4. Select a type of day for Recurrence.