ETC Halcyon Gold - Set Fan Options; Set Gobo Color Correction; Set Units for Temperature Display; Set Display Options

Configure the Fixture 20
Set Fan Options
Navigate:Main Menu → Settings → Fans
Select the fan mode for the fixture.
• Standard
• Studio - reduces fan noise, but decreases fixture output by approximately 20%
Note: Fan speed DMX control overrides the Fans setting in the fixture user interface
when the DMX control is set to Auto or Studio. See the Halcyon Gold DMX Channel
Map Reference Guide for details: etcconnect.com/Halcyon/Documentation.
Set Gobo Color Correction
Navigate:Main Menu → Settings → Gobo Color Correction
• OFF (default for High Fidelity fixtures)
• ON (default for Ultra-Bright fixtures)
When set to On, the fixture automatically uses the CTB slot of the color wheel whenever a
gobo is used and no color is mixed or used on the color wheel.
When set to Off, the fixture does not use the color wheel with gobos unless it is programmed
to do so.
Set Units for Temperature Display
Navigate:Main Menu → Settings → Temperature Units
Set the units in which temperature is displayed.
• Celsius (default value)
• Fahrenheit
Set Display Options
Navigate:Main Menu → Settings → Display
Menu Item Options Description
Timeout 1minute–
60minutes
Set the amount of time the fixture waits after the last
user interface interaction until the display goes to
sleep. The default is 5minutes.
Flip Off Set the orientation of the display.
• Off: The orientation of the display does not
change.
• On: Overrides the Auto setting and flips the
display 180°.
• Auto: The fixture determines the orientation of
the display based on how the fixture is mounted.
On
Auto
Brightness 10%–100% Set the brightness of the display. To change the
brightness, drag the slider left or right in the display
or tap the left and right navigation buttons.