Maintenance 30
Maintenance
CAUTION: RISKOFELECTRICSHOCK!Disconnect power before servicing.
ATTENTION : RISQUE DE CHOC ÉLECTRIQUE!Couper l'alimentation avant
l'entretien.
To ensure that the fixture remains in good working condition and does not fail prematurely,
ETC recommends that you perform regular maintenance on the fixture.
Keep the following in mind during regular service and inspection:
• All screws for installing the fixture or parts of the fixture must be tightly connected and
must not be corroded.
• There must not be any deformations to the housing, lenses, rigging, and installation
points (ceiling, suspension, trussing).
• Moving parts must not show any signs of wear and must move smoothly without issue.
• The power supply cables must not show any damage, material fatigue, or sediment.
• If spare parts are required, order only genuine parts from ETC or your authorized ETC
dealer.
Clean the Fixture
1. Clean the inside and outside of the lens regularly using a damp, lint-free cloth to avoid
loss of output due to accumulation of dust/dirt on the lens. Never use alcohol or solvents.
2. Clean the fans regularly to ensure maximum airflow and efficient cooling. This will
ensure that the light source operates in the best possible condition.
Note:
If you use compressed air to clean the fans, hold the fan blades in place while
cleaning them. Letting the fans spin while using compressed air could damage the
fans.
Replace the Fuse
The fuse in this fixture is not user-replaceable. Contact ETC Technical Services for assistance.
See
Help from Technical Services on page 2
for contact information.
To Next Page
Loading...
