29 Halcyon Gold User Manual
Prism_Rot 2
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Prism rotating wheel 2 is not located in the default position after the reset
Tilt
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Tilt movement is not located in the default position after the reset
Zoom
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Zoom wheel is not located in the default position after the reset
To Next Page
Loading...
