ETC Halcyon Gold - Page 33

Error Codes 28
Gobo 2
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Gobo Wheel 2 is not located in the default position after the reset
Gobo Rot 1
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Gobo Rotating Wheel 1 is not located in the default position after the reset
Iris
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Iris is not located in the default position after the reset
Pan
This message displays after the reset of the fixture if any of the following conditions exist:
• the yoke’s magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Pan movement is not located in the default position after the reset
Prism 1
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Prism wheel 1 is not located in the default position after the reset
Prism 2
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Prism wheel 2 is not located in the default position after the reset
Prism_Rot 1
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Prism rotating wheel 1 is not located in the default position after the reset