ETC Halcyon Gold - Page 32

27 Halcyon Gold User Manual
CMY
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head's magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the CMY wheel is not located in the default position after the reset
CTO Color
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head's magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the CTO wheel is not located in the default position after the reset
Focus
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Focus wheel is not located in the default position after the reset
Frost 1
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Frost wheel 1 is not located in the default position after the reset
Frost 2
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Frost wheel 2 is not located in the default position after the reset
Frost 3
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Frost wheel 3 is not located in the default position after the reset
Gobo 1
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• Gobo Wheel 1 is not located in the default position after the reset