32 Electronic Theatre Controls, Inc.
5. If there is no configuration, does resetting change this?
To reset the system, press [Reset] on the CEM and wait for 30 seconds.
▼ To access the Setup Information menu, press [Setup] [3] [Enter]
[Enter] [↑] [Enter].
The second line of the Setup Information menu shows how many wall
stations are in the configuration and how many are linked to the
Architectural Processor. If the number after [Sta:
is not zero, there is a
configuration present.
6. Have you been downloading configurations recently?
If you or anyone else has installed a new version of your configuration
software or edited rooms, macros or time clock events using Light
Manager software, you have downloaded configurations to your
Architectural processor.
7. Please describe any events that might be related to the system
malfunction:
Events that happened to or around your Unison system before the
problem occurred may have affected its performance. Some example:
Have you experienced recent power outages or lightning strikes?
Has there been building construction/repairs near your system?
Did the problem occur while someone was downloading a configuration
or using Light Manager for live control or system monitoring?
Did the problem happen when someone was using the system to adjust
light zone intensities, or during a period of inactivity (night or weekend)
when the system was not in use?
Could the problem be related to a macro or time clock activation?
Setup Information
[Sta: 15 Con: 15]
LCD display
To Next Page
Loading...
