EasyManua.ls Logo

EUFAB AMBER 4 - Folding Mechanism Operation; Maintenance and Care; Notes for Environmental Protection; Contact Information

EUFAB AMBER 4
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Tension-relief strap
Now pull the tension-relief strap tight.
Tension-relief strap
In order to release the tension-relief strap, press the lock down (Figure 6, Position 1) and pull the strap out of the lock.
To open the car boot, you may fold the rack down, even if bicycles are mounted.
To do this,  rst loosen the block of the folding mechanism by pushing the locking bolt down and pushing the handle away from you . Hold the U-bracket or
bicycles with one hand, with the other hand pull the lever of the folding mechanism upwards . Now you can fold the rack down.
The tension-relief strap may not cover the third braking light.
The tension-relief strap may not in uence the functionality of the rear windscreen wipers.
6. MAINTENANCE AND CARE
7. NOTES FOR ENVIRONMENTAL PROTECTION
5.5 FOLDING OUT THE BICYCLE RACK
If you wish to operate the folding mechanism, always hold the U-bracket with one hand to ensure that the rack
is not able to fold out suddenly. (Risk of injury)
The bicycle rack may not be used without this safety mechanism.
5.6 FOLDING THE BICYCLE RACK UP
Raising the rack platform engages it back into the transport position (you will hear a click). Secure the folding mechanism again by pushing the locking bolt
down and pulling the handle towards you.
After use, store the bicycle rack in a clean and dry place. Wash any mud or other dirt o using water.
Keep the trailer coupling clean and free of grease
Check the bicycle rack regularly for damages. Damaged or worn parts must be replaced immediately. Only original replacement parts may be used.
Check the bolts and nuts of the bicycle rack regularly and tighten when necessary.
Immediately treat any damage to paintwork with paint.
Regularly lubricate rotating and moving parts.
Due to its lighting system, the bicycle carrier is an electrical device.
Do not dispose of electrical appliances in household waste! Discarded electrical and electronic equipment must be collected separately and
recycled in an environmentally sound manner.
Contact your municipal or city government on how to dispose of old electronic equipment.
The materials are recyclable. You are making an important contribution to protecting our environment through recycling, material recycling or
other forms of re-utilising old appliances!
Dispose of the bicycle rack in accordance with the laws and conditions in your country.
8. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
Connect both parts of the tension-relief strap as shown on Figures 5 to 7.
Figure 5 Figure 6 Figure 7

Table of Contents

Related product manuals