FILLING THE DETERGENT SOLUTION TANK
The tank should be filled using clean water mixed with an appropriate detergent solution suited for the type of
floor and for the dirty conditions of the floor and using a product suitable for cutting down foam.
Before filling the tank, fit the brush or the disc pad holder on the machine.
To correctly fill the tank, the machine must be in work position as in fig. 1 with the brush (pos. A) resting on
the ground.
Do not fill the tank with the machine in transport or parking position as in fig. 2 with the brush (pos. A) raised.
In this case, more water would be loaded than necessary and this would come out of the overflow pos.B on the
level pipe and through the loading opening when the brush is lowered.
To fill the solution tank use the opening on the tank pos. 1.
To pour water into the tank use either a rubber hose pos. 2 connected to the supply mains or a bucket pos. 3. In
this case, make sure it is clean.
The water used to fill the tank must not exceed a temperature of 50 °C.
For detergent percentages, mixing procedures and safety requirements, see the indications on the pack.
Use low-foam liquid detergents or a product suitable for reducing foam.
Fill the tank until MAX LEVEL is reached, as indicated on the tank opening. Do not exceed this level.
The level inside the tank is displayed by means of the transparent pipe pos. 4.
IMPORTANT: DO NOT POUR INFLAMMABLE LIQUIDS INSIDE THE TANK.
To Next Page
Loading...
