CAUTION: USE PROTECTIVE GLOVES AND GOGGLES WHEN HANDLING BATTERIES,
AVOIDING ANY CONTACT WITH THE ACID INSIDE THE BATTERIES.
CAUTION: THE BATTERY CHARGER IS SET ACCORDING TO THE TYPE OF BATTERIES SHOWN
IN THE SHEET ATTACHED TO THE USER’S MANUAL.
IF YOU WANT TO MOUNT BATTERIES WITH DIFFERENT TYPE (I.E. LEAD-ACID, AGM/GEL. AGM
ZENITH. OR GEL SONNENSCHEIN) THE SETTING SHOULD BE DONE ON THE BATTERY
CHARGER. CONTACT A RESELLER OR A TECHNICIAN FOR SUCH AN OPERATION.
ATTENTION: TO AVOID THE VOLTAGE UNBALANCE FOR MACHINES IN 24V
PLEASE SWITCH THE POSITION OF THE BATTERIES EVERY 4 MONTHS.
Refer to the specification sheet for battery types and sizes suitable for the machine.
Follow the instructions below to mount the batteries to the machine:
park the machine on a flat surface and remove the key (if available).
WARNING: BEFORE MOUNTING THE
BATTERIES, FIT THE BRUSH POS. 1
ON THE BRUSH PLATE.
THIS ALLOWS KEEPING THE
PLATFORM IN HORIZONTAL
SURFACE SO THAT THE BATTERIES
POS. 2 CANNOT SLIP ON THE
GROUND.
WARNING: IF THE BRUSH IS NOT
FITTED ON THE BRUSH PLATE POS. 1,
THE BATTERIES PLATFORM POS. 2
WILL BE TILTED AS SHOWN IN THE
PICTURE AND THE BATTERIES
MIGHT SLIP ON THE GROUND. THIS
MIGHT CAUSE THE BROKEN OF THE
DOOR POS. 3.
To Next Page
Loading...
