Eureka E50 - Recharging Batteries

To Next Page

To Previous Page

CLEAN THE COOLING GRID OF THE

VACUUM MOTOR

To clean the cooling grid follow the

instructions below:

 Bring the machine into a stop

position in a flat surface area, turn it

off;

 Remove the carter pos. 1;

 Check and eventually clean the

cooling grid of the vacuum motor

(pos. 2).

MAINTENANCE SCHEDULE

DAILY MAINTENANCE (EVERY TIME AFTER THE MACHINE HAS BEEN

USED)

 Empty and clean the recovery tank (see page 23-24);

 Remove and clean the anti-foam device. Wash the float filter (see page 23-24);

 Wash the squeegee vacuum pipe (see page 23-24);

 Empty and clean the solution tank (see page 25);

 Clean the squeegee blades (see page 27);

 Check the splashguard (see page 29);

 Check and clean the brushes. Make sure there are no twisted cables or metal wires (see page 18).

WEEKLY MAINTENANCE

 With lead acid batteries, once the batteries are charged make sure to check the electrolyte level and if

necessary fill it up only using distilled water

 Clean the detergent solution filter (see page 26);

 Check and if necessary rotate or replace the squeegee blades (see page 27-28);

 Check the splashguard (see page 29);

 Check the condition of the brush. If it is damaged, replace it or in any case replace it when the length of the

bristles reaches 10 mm (see page 18);

 Check and eventually clean the cooling grid of the vacuum motor (see page 32);

 Clean the machine with a damp cloth.

Other manuals for Eureka E50