Eureka E50 - Recovery Tank Drain Valve Cleaning

29
DRAINING AND CLEANING THE SOLUTION TANK
After completing the washing operation, in order to drain any leftover water from the solution tank, proceed as
follows:
 Disengage the brush function and close the solution tap if the machine does not feature a
solenoid valve and place the machine in raised-brush position;
 After drying, raise the squeegee by means of the lever provided. After a few seconds turn off
the vacuum unit and move to the area dedicated to tank emptying, stopping on a flat section of
floor;
 Put the key in pos. 0;
 Release the clean water level clear pipe (position 2) from its seat (pos. 1);
 Open the cap (position 3) and lay the pipe on the ground;
 Once the tank is drained, put the cap back into the pipe and place it into its special housing;
 It is recommended to flush the tank using only water once it is drained completely and then empty it; this
will help prevent incrustations due to the detergent solution;
CHECKING BRUSHES OR ABRASIVE DISCS
After using the machine, remove the brushes or discs manually:
 Check the condition of the brushes and replaced them if they are worn out (the length of the lower bristle
shall not be less than 10 millimeters);
 Check the condition of the abrasive discs and replace them if worn out.