Eureka E50 - Using the Machine; Check Before Use; Operation

27
PERIODIC SERVICING
INTRODUCTION
REGULAR AND PERIODIC SERVICING OF YOUR SCRUBBER GUARANTEES OUTSTANDING
PERFORMANCE OF THE MACHINE AND ITS LONG LIFE. THE PAGES THAT FOLLOW CONTAIN
THE INFORMATION THAT WILL HELP TO PLAN THE CARE AND THE SERVICING THAT THE
SCRUBBER NEEDS.
WARNING!
DO NOT CARRY OUT ANY MAINTENANCE OPERATION NEITHER ON THE MACHINE NOR ON ITS
COMPONENTS WITHOUT HAVING FIRST STOPPED THE MACHINE, PUT IT ON A FLAT FLOOR
AND DISCONNECTED THE STARTING BATTERY CONNECTOR.
ANY OTHER TYPE OF SERVICE OPERATION MUST BE CARRIED OUT BY QUALIFIED
PERSONNEL OR AUTHORISED SERVICE CENTRES ONLY.
WARNING!
DO NOT TAMPER WITH ANY SAFETY-RELATED PART.
THESE CAN BE REMOVED ONLY AS PART OF THE MAINTENANCE OF AN AUTHORISED
SERVICE CENTRE.
DRAINING AND CLEANING THE RECOVERY TANK
The recovery tank must be drained and cleaned after each washing operation
In order to drain and wash the tank proceed as follows:
 Switch off the brush function, close the solution tap if the machine does not feature a solenoid valve
and place the machine in raised-brush position;
 Complete drying, raise the squeegee by means of the lever provided. After a few seconds switch off the vacuum unit
and move to the area dedicated to tank emptying, stopping on a flat section of floor;
 Put the key in pos. 0;
 Remove the dirty water tank drain pipe pos.1;
 Remove the safety cap pos. 2;