Eureka E50 - Important Communication; General Warnings and Advice

7
GENERAL WARNINGS AND ADVICE
DANGER SIGNS - ATTENTION
THIS SYMBOL HIGHLIGHTS ALL THE OPERATIONS THAT REPRESENT A
POTENTIALLY HAZARDOUS SITUATION FOR THE OPERATOR
IT IS THEREFORE NECESSARY TO ADHERE CLOSELY TO THE CONDITIONS
SHOWN BY THIS SYMBOL.
GLOVES MUST BE WORN
SAFETY GLASSES OR GOGGLES MUST BE WORN
BE CAREFUL NOT CRUSH YOUR HANDS BETWEEN PARTS IN MOTION
ATTENTION: DO NOT GET IN TOUCH WITH WATER.
THE DEVICES MARKED WITH THIS LABEL ARE NOT TO GET WET. (USUALLY
THEY ARE ELECTRICAL COMPONENTS)
AN ANTI-VAPOUR MASK HAS TO BE WORN WHEN USING CORROSIVE
DETERGENTS.
EMERGENCY SITUATIONS
ONLY EXTINGUISH FIRES WITH POWDER FIRE EXTINGUISHERS
CLEANING AND MAINTENANCE
The machine must be cleaned by persons who have received proper instruction for the purpose, who know how to cut off
the sources of energy and who know the characteristics of the machine so as not to find themselves in a hazardous
situation. Clean the machine coverings, the panels and commands with cloths soaked in water or a detergent solution.
Solvents such as petrol, alcohol, etc. must not be used.
Call in specialized personnel to clean the electrical components. Said personnel should use products that are not corrosive
and are anyway suitable for electrical circuits.
Specialized personnel with thorough knowledge of the machine and its components must be called in to carry out
maintenance operations. Any maintenance and cleaning operation must be carried out with the machine off, with all the
mechanisms still, after the hot sections have cooled down and with the battery disconnected. When using compressed air
guns for cleaning, protect the eyes and hair
STORING THE MACHINE
If the machine is not used for a long period, it is essential:
- To recharge the batteries before storing the machine as empty batteries may get damaged;
- To empty and wash the tanks as described in the relative section;
- To clean the clean water filter and empty it completely;
- Should the machine be equipped with the detergent dosing system, clean the water circuit and allow for water-
flowing before storing the machine;
- To clean the machine inside and outside;
- To keep brushes and squeegee raised;
- To lock the machine in place with the parking brake;
- To remove the key;
- To remove the battery lead connections;
- To keep the machine in a protected place;
- To keep the machine within a temperature range of 5 °C / 40 °C;
- To keep the machine within a humidity range of 30% / 80%.