Ever SINLINE RT - STARTING up the UPS UNIT (Power Supply from the Mains); STARTING the UPS up from the BATERY (Cold Start)

EVER UPS SINLINE RT / RT XL series instruction manual
2017-04-26 12:41
Pomoc Techniczna, tel.: +48 61 6500 400
www.ever.eu
52
After these steps are completed, the unit begins normal operation.
CAUTION! The battery reaches full capacity after approximately a month
of mains operation mode.
CAUTION! To maximize the performance of the battery, we recommend
formatting it by discharging and recharging the battery three times.
STARTING UP THE UPS UNIT (power supply from the mains)
Once the UPS unit is correctly connected, start the unit by following these steps in
sequence:
1. Make sure the UPS unit's power cord is connected.
2. Press and keep the key on the UPS unit's front panel depressed for over 1
second to switch the device on.
3. Switch on the UPS logically with the control panel (MENU; CONTROL; UPS
Enabled).
4. Make sure no active alarms or messages are displayed on the screen. If any
such alarms or messages are present, check their meaning in the "Diagnostics
of errors reported by the UPS".
5. The icon shown on the display and the activated green LED indicate that
the UPS unit operates in mains (normal) mode. All devices connected to the
UPS are supplied with power and protected.
STARTING THE UPS UP FROM THE BATERY (cold start)
The start the UPS up when there is no power in the mains (the so-called "cold start")
follow these steps:
1. Press and keep the key on the UPS unit's front panel depressed for over 1
second to switch the device on.
2. Switch on the UPS logically with the control panel (MENU; CONTROL; UPS
Enabled).