EVER UPS SINLINE RT / RT XL series instruction manual
Pomoc Techniczna, tel.: +48 61 6500 400
Output Power (Apparent / Active)
1)
MECHANICAL SPECIFICATIONS
Dimensions - Rack (H x W x D)
Dimensions – Tower (H x W x D)
440 x 88 x 430 mm
(UPS)
450 x 260 x 430 mm
(UPS + 2 supports for
tower position)
440 x 132 x 460 mm (UPS)
450 x 304 x 460 mm (UPS + 2
supports for tower position)
440 x 132 x
630 mm
(UPS)
450 x 304 x
630 mm
(UPS + 2
supports
for tower
position)
Transport Dimensions (H x W x D)
Position in which devices transported
Output cables maximum length
Input over current protection
Short-circuit protection –
Circuit breaker
10 A / 250 V AC
Short-circuit protection – Circuit breaker
16 A / 250 V AC
Output over current protection
Electronic short-circuit and overload protection
DC over current (internal batteries)
DC over current (external battery input)
ACCESSORY AND EXTRA FUNCTIONS
Output connection (number and type of
sockets )
3 x IEC320 C13 (10 A)
2 x PL
3 x IEC320 C13 (10 A) - controllable
3 x IEC320 C13 (10 A)
1 x IEC320 C19 (16 A)
2 x PL
Acoustic and optical; LCD graphic display, LED
Communications interfaces
PN-EN 62040-1:2009, PN-EN 62040-2:2008
Note: The manufacturer reserves the right to change the above listed parameters without notice.
* Charging time up to 90% battery capacity, following discharge with load equal to 80% Pmax (until the UPS switches off).
REMARKS:
1)
To ensure normal operation of the UPS unit, the load at its output should not exceed 80% of the value given in the chart. A
power reserve is necessary to maintain continuity of operation of connected appliances in case of momentary surges of load
current.
2)
The Rack Kit is available as an option.
3)
Constant exposure of the device to environment temperature over +25°C results in reducing battery life.
4)
Maximum allowed load the UPS unit will decrease as the altitude above the sea level increases over the specified limit.
To Next Page
Loading...
