Eversys Enigma Classic E'2ct - Rinse; Pre-Heat Rinse; Auto-Rinse

Operation 5
5700109748 | V01-09/2021 55/ 132
5.3 Rinse
To Initialise the Enigma, it is necessary to rinse after each startup. Each time a rinse is necessary this
button will flash.
A. It is possible to rinse at any time by pressing the Rinse (1) button.
Top layer example:
5.3.1 Pre-heat rinse
After 10 min. idle mode (no drink is being made), a pre-heat rinse is requested by the machine if this
function is activated.
5.3.2 Auto-rinse
Rinsing is not a substitute for daily cleaning! Auto-rinsing is necessary to remove residue build-up in the
coffee and milk systems.
The Enigma automatically rinses after certain time intervals as well as when it is switched ON or OFF.
The Rinse button dispenses hot water.
Depending on settings, the Rinse button will display either in the products area or on the top layer.
Refer to chapter
“11.3 User rights” on page 124 for more information.
Fig. 5-3
To activate or deactivate this function, please contact your local service organisation.
1