Eversys Enigma Classic E'2ct - Steam Nozzle Cleaning

7 Care
90/ 132 Enigma User Manual | © Eversys S.A.
7.3.8 How to clean the steam nozzle
A. Switch off the machine at the main switch (see “5.9 Switch off” on page 63).
B. Remove the nozzle (1).
C. Ensure to not remove (2) the white seal (only on steam wand V1, this seal is not available any on steam
wand V2; manufactured after May 2021).
D. Wash the nozzle with soft soap and clean water using a soft brush (3).
E. Tighten the nozzle (4).
F. Check that there is no gap between the seal and the nozzle (steam wand V1) (5).
Only necessary to clean the nozzle monthly or if required.
Fig. 7-20
4
3
5
1
2