EMC-DCP
EMC DESKTOP CONTROL PANEL
Revision 1.1 Page 13
The Setup Menu options are shown in Figure 3-11.
A
IP
192 168 9 90
Setup
Menu
Exit
Save &
Exit
Shaft
Encoder
1 2 3 4 5
Top
Row
Menu
Row
Figure 3-11: EMC-DCP Setup Menu
Starting from the Top Row, the first large LCD button displays the name of the Menu, in this case,
Setup Menu. The next LCD button is labeled “Exit” and is used to exit the Setup Menu WITHOUT
saving the changes. The last LCD button in this row is labeled “Save and Exit” and is used to save the
changes and exit the Setup Menu.
The next row is called the Menu Row. This is the row where the main EMC-DCP parameters are set.
Use Shaft Encoder 1 to scroll through the parameters (see Table 3-2) and Shaft Encoders 2 to 5 to set
the parameter values.
EMC-DCP Parameter Description
Sets the IP address of Ethernet A on the EMC-DCP. The format of this
parameter is XXX.XXX.XXX.XXX.
Sets the Subnet mask of the network for Ethernet A on the EMC-DCP. The
format of this parameter is XXX.XXX.XXX.XXX.
Sets the Gateway Address of the network for Ethernet A on the EMC-DCP.
The format of this parameter is XXX.XXX.XXX.XXX.
Sets the IP address of Ethernet B on the EMC-DCP. The format of this
parameter is XXX.XXX.XXX.XXX.
Sets the Subnet mask of the network for Ethernet B on the EMC-DCP. The
format of this parameter is XXX.XXX.XXX.XXX.
Sets the Gateway Address of the network for Ethernet B on the EMC-DCP.
The format of this parameter is XXX.XXX.XXX.XXX.
Sets the Q-Link address of the EMC-DCP panel. The parameter ranges
from 0x00 to 0xFF.
Sets the brightness of the LCD buttons on the EMC-DCP panel. The
parameter ranges from 0% to 100%.
Sets the brightness of the LED buttons on the EMC-DCP panel. The
parameter ranges from 0% to 100%.
Configure NIC A for auto (default), 10Mb full duplex or 10Mb half duplex.
Configure NIC B for auto (default), 10Mb full duplex or 10Mb half duplex.
Table 3-2: EMC-DCP Parameter Options
To Next Page
Loading...
