evertz EMC-DCP - Testing EMC-DCP Setup; EMC-DCP Layout for PKG9625 SW;PKGHD9625 SW Users; Mini Master Control Panel Layout

EMC-DCP
EMC DESKTOP CONTROL PANEL
Page 18 Revision 1.1
3.9. TESTING EMC-DCP SETUP
To test the configurations, the user should connect a PC to the same network as the 3025EMC or
QMC-2 or 9625SW and EMC-DCP. The user should then PING each the 3025EMC or QMC-2 or
9625SW and EMC-DCP. If there are replies, then the connections are correct. If there are no replies,
check the IP addresses and Ethernet connections of the 3025EMC or QMC-2 or9625SW and EMC-
DCP.
For 3025EMC or QMC-2 users, the next0 step is to check the Q-Link ID. If the Q-Link ID was set
correctly, the panel will display the button configuration set by the user using the QMCSetup software.
If not, the panel may report No Q-Link Comms. The user should check the Q-Link ID on the EMC-DCP
and on the EMC Setup configuration file.
3.10. EMC-DCP LAYOUT FOR PKG9625SW AND PKGHD9625SW USERS
Unlike the QMC-2, the PKG9625SW or PKGHD9625SW does not allow for user configurable EMC-
DCP panel layouts. The EMC-DCP only comes in one layout. The EMC-DCP layout for PKG9625SW
or PKGHD9625SW is shown in Figure 3-16.