EMC-DCP
EMC DESKTOP CONTROL PANEL
Revision 1.1 Page 25
From the upgrade webpage, click “Browse” to navigate to the location of the “.efp” file that you need to
install. Note that there are two different file types. If the EMC-DCP is to be used with a QMC-2/3025
system then the “emcdcp-update-x.x.x.x.efp” upgrade file must be used. If the EMC-DCP is to be used
with a PKG9625SW system then the “emcdcp-switcher-update-x.x.x.x.efp” upgrade file must be used.
When the appropriate upgrade file has been selected, click “Install”. The result of the upgrade process
will be shown at the bottom of the page under the status header.
To complete the install process click “Reboot” to reboot the panel. Please note that the webpage will
not update to show that the EMC-DCP panel updated successfully.
To Next Page
Loading...
