62
1. To enter setup mode: use the IR remote near the door station reader, then press
*# 1234 # to enter setup mode (factory default password 1234).
2. Setting up cards in zone 1
a.
E
nter setup mode
b.
A
dding cards: press button 1 on the controller (a long "biii..." sound), attach th
e
RFID (a short "bi" sound indicates successful addition). Press ** to exit (if the
"
bibi" sound is heard, it means the card has already been used".
c.
To
remove zone 1 cards: press 2 on the controller, attach the RFID card you
want to remove to the door unit, press ** to exit.
3. Setting up cards in zone 2
a. Enter setup mode
b. Adding cards: press button 7 on the controller (a long "biii..." sound), attach the
RFID (a short "bi" sound indicates successful addition). Press ** to exit (if th
e
"
bibi" sound is heard, it means the card has already been used".
c.
To
remove zone 2 cards: press 2 on the controller, attach the RFID card you
want to remove to the door unit, press ** to exit.
4. Setting up the Administrator card and adding cards using the Administrator card
a.
E
nter setup mode
b.
To
add an admin card for zone 1: press 00 on the controller, attach one card as
an admin card, press ** to exit. And then attach administrator card 1 and then a
new user card. To finish adding, reattach the administrator card.
c.
To
add an admin card for zone 2: press 33 on the controller, attach one card as
an admin card, press ** to exit. And then attach administrator card 1 and then a
new user card. To finish adding, reattach the administrator card.
d.
To
set up admin delete cards: press 66, swap one card as admin delete card,
press ** to exit. Attach the administrator card for deletion and the user card for
zooming. Card ID for deletion. Finally, swap the admin tab for delete to exit.
5
.
Delete all cards
a.
E
nter setup mode
b.
E
nter 99 to delete all cards. 5 seconds later a long bi...tone is heard, indicating a
successful deletion.
6. Change the default password
a.
E
nter setup mode
b.
P
ress 8 and then enter 4 digits as the new password for the settings. Press # to
confirm. And then enter the same new password and confirm the # again. Press
** to exit.
7. K1 button settings
a. Restore the factory default password
i.
P
ress the K1 switch on the back of the door station and charge the power
until the bi tone sounds.- The password is reset to factory 1234
b. Administrator card settings
To Next Page
Loading...
