EVS Multicam LSM User Manual

Multicam Behavior
When adding a cut to a clip, Multicam will behave as follows:
• The transition applied at the cut point is a cut (for both audio and video).
• The speed of the cut elements is the same as the original element, even if it is
“Unknown”.
• The stop and start modes of the cut elements are auto.
• Any loop defined on the playlist that includes the original element conserves and
includes the cut elements.
• Any tag defined and active on the original element at the cut point is recreated at the
short-in of the second cut element.
The adding cut is not possible in the following cases:
• Within a video effect.
• Within an audio effect beginning or finishing the original element.
5.7.6. Trimming Clips into a Playlist
Introduction
Every playlist element can be trimmed independently of all other instances of the same
clip number. Trim actions are only available in the Remote Panel.
102 5. Playlist Management
EVS Broadcast Equipment SA Issue 12.05.A- May 2014

EVS Multicam LSM Specifications

General

Brand	EVS
Model	Multicam LSM
Category	Remote Control
Language	English