How to Change the Audio Effect Duration
To change the audio effect duration, proceed as follows:
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press SHIFT+V Base (A).
4. Press to highlight A Fx Dur (C).
5. Move the lever to adjust the value.
5.8.6. V Base Editing in Split Audio
Description
In a V Base edit, you delay or advance the beginning of the audio transition compared to
the video transition of the clip. VBase Editing is only available on the Remote Panel.
Note
When editing a playlist in V Base or A Base, the video transition information will
be on the top line of the OSD display, whereas the audio transition information
will be on the bottom line of the OSD display.
How to Insert an Audio Delay
Inserting an audio delay consists of delaying the beginning of the audio transition
compared to the video transition. The Start on Cut and End on Cut are not taken into
account in these editing actions.
To insert an audio delay, proceed as follows:
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press to highlight V Base (SHIFT+A).
4. Press to highlight A Delay (B).
5. Enter a value with the F_ keys including leading zeros (0+2+1+2= 2:12).
6. Or move the lever and press ENTER.
The value entered will be present on the PRV SCREEN when the clip is next to play in a
playlist.
OPERATION MANUAL Multicam LSM 12.05
5. Playlist Management 119
To Next Page
Loading...
Need help?
General
