Practical Example
1. The operator builds a playlist with Fills and another playlist with Keys.
2. He sets the Playlist Load parameter to Conditional in the setup menu.
3. He enters the 2PGM mode.
4. He selects the Fill playlist as current playlist, presses A to gain control on PGM1.
5. Then he presses PLST two or three times to enter the PLST DIFF mode and cue up
the Fill playlist to its 1st clip.
6. Then he presses the TAKE key to return to the PGM selection menu.
7. He selects the Key playlist as current playlist, presses B to gain control on PGM2.
8. Then he presses PLST two or three times to enter the PLST DIFF mode and cue up
the Key playlist to its 1st clip.
9. Then he presses the TAKE key to return to the PGM selection menu, presses D to
gain control on both PGM channels. He presses TAKE to enter the PLST DIFF menu
He will see the content of both playlists side by side on the LCD screen, and can browse
them or play them in Sync at any speed, and perform SKIP and He presses TAKE to
enter the PLST DIFF menu commands as needed.
3.3.3. Multi PGM Secondary Menu Controls
The secondary menu can be called by pressing the MENU key and is similar to the
1PGM+PRV mode, except that the A function is empty since it is not possible to create a
transition between the channels in this mode.
See section "1PGM+PRV Secondary Menu Controls" on page 24 for a description of the
other functions of the secondary menu.
OPERATION MANUAL Multicam LSM 12.05
3. Control Modes 31
To Next Page
Loading...
Need help?
General
