9.3.2. Accessing the Offside Line Mode
1. To activate the Offside Line mode, set the following parameters in the Operational
Setup menu on the Remote Panel:
◦ Set the Internal offside line parameter (p.12.3 F1) to Yes.
◦ Set the Epsio parameter (p.12.3 F2) to No.
Note
When you activate the offside line, you can no longer use a second controller.
2. When the offside line mode is active, the Offside Line option is available from the
operational menu in the PGM/PRV or Multi PGM mode:
Rst Cam Local Sync Prv OFFSIDE
Cam A Cam B
3. Press the SHIFT+D key to access this mode .
OPERATION MANUAL Multicam LSM 12.05
9. Advanced Control Modes 193
To Next Page
Loading...
