• Cue points can be marked across several blocks but the recall is limited to the
currently selected block.
Example:
◦ While recording on memory block 1, mark cue points 1, 2, and 3 on memory block
1.
◦ Press TAKE to start recording on block 2 and mark cue points 1, 2, and 3.
◦ Press TAKE and select memory block 2. The Last Cue command scrolls through
the cue points of block 2.
◦ To go through cue points of another block, select that block first then press Last
Cue.
• On OSD, the first information, displayed in white, refers to the cue points on the
playing block while the second information, displayed in red, refers to the recording
block.
9.6. Video Delay
When the Multicam software has been configured with a base configuration = Video Delay
in the Channel Parameters menu, the Delay Screen will appear automatically when the
application is started. In this case, all play channels will be available from the Delay
screen.
If Multicam is running a base configuration different than Video Delay, this screen can be
called manually from the Clip screen, Playlist Screen or Network Screen by pressing
SHIFT+F7 on the keyboard. In this case, only the play channels assigned to user #1 (i.e.
the 1
st
EVS Remote Panel if the base configuration is LSM or maXS, or the 1
st
protocol if
the base configuration is in slave mode).
OPERATION MANUAL Multicam LSM 12.05
9. Advanced Control Modes 225
To Next Page
Loading...
Need help?
General
