RECORD
This key corresponds to the ‘ARM’ or ‘REC’ commands on hypermotion cameras.
The different behaviors are possible, depending on various conditions:
• In single-block memory, pressing this key deletes the material recorded on the camera
and starts the recording process on the camera.
• In multiple-block memory:
◦ When you press RECORD after selecting the block number you want to work
with, all A/V material recorded on the memory block(s) of the camera is deleted,
and the camera starts recording on the first block.
◦ When you press RECORD subsequently and a memory block is selected, the
recording starts on the currently selected memory block, and its content is
deleted.
◦ When you press RECORD subsequently and no memory block is selected, all
A/V material recorded on the memory block(s) of the camera is deleted, and the
camera starts recording on the first block.
◦ When you press RECORD subsequently and the selected memory block is
recording, the behavior differs from one camera to the other. Refer to the chapter
dedicated to the camera itself.
TAKE
This key corresponds to the ‘Trig/Stop Rec’ command on hypermotion cameras.
With a single-block memory or when the last block is reached, press TAKE to stop the
recording.
With a multiple-block memory, pressing TAKE induces the following actions:
• The recording stops on the current block.
• The material on the current block is loaded on the camera in play mode.
• The recording starts on the next empty block, if available. If no empty block is left, the
recording stops.
Lever
There is no corresponding command on hypermotion cameras.
Press the Lever key to shift to the secondary lever range (defined in the 2nd Lever
parameter in the hypermotion secondary menu) for material played out using the
hypermotion feature.
204 9. Advanced Control Modes
EVS Broadcast Equipment SA Issue 12.05.A- May 2014
To Next Page
Loading...
Need help?
General
