To Next Page

To Previous Page

Last Cue Parameter

The Last Cue parameter defines the Last Cue button function when the Cuesparameter is

Off.

Off Ramp UP SpeedBrk LSM Mode

Block 1 Block 2

• The Last cue parameter can be set to Ramp Up (the default value):

◦ The first time the Last Cue button is pressed, the speed is increased starting from

the PGMSpeed until the maximum speed is reached. This maximum speed

depends on the camera model.

◦ Whenever the Last Cue button is pressed again, the speed is increased starting

from the last speed used until the maximum speed is reached.

• The Last Cue parameter can be set to an individual speed (the available values

depends on the camera model).

Note

• When Cues is set to Off, the cam key is displayed in black and the Mark

button is inactive.

• When Cues is set to Off and Last Cue is set to Ramp Up, press

Clear+Last Cue to reset the speed to PGMSpeed.

Speedbreak Parameter

When the Speedbreak functionality is available, it will be displayed as illustrated.

Press the corresponding key to activate (highlighted) or deactivate it (normal display).

Off Ramp UP SpeedBrk LSM Mode

Block 1 Block 2

See section "Using Speedbreak" on page 211

Note

Currently, the Speedbreak functionality is available only for Vision Research

and NAC Hi-MotionII cameras.

Hypermotion Secondary Menu

From the hypermotion main menu, press the MENU key to open the hypermotion

secondary menu illustrated hereunder.

# Blocks Pre-Roll PGMSpeed 2ndLever

2 00s10fr 50% +- 1000

206 9. Advanced Control Modes

EVS Broadcast Equipment SA Issue 12.05.A- May 2014

EVS Multicam LSM User Manual

Other manuals for EVS Multicam LSM