played at considerably higher pitches.
The Z knob/CV selects the sample. The transition from one sample to the next is a smooth
crossfade. Note that if the sample has the 'retriggerOnSampleChange' option set to 0, changing Z
will not change the sample – it will only change when playback is stopped and restarted (by the X
CV or manually via parameter 3).
A & B are the left & right audio outputs respectively.
Parameter 0 is the standard sample folder parameter, described above.
Parameter 1 shifts the pitch up & down by octaves. (Note the comments above on how high the
pitch may be raised.)
Parameter 2 sets the crossfade time, in percent of the sample time.
Page 89
To Next Page
Loading...