ExRobotics ExR-2 - Page 51

ExRobotics B.V.
ExR-2 Robot
Operating Guide
Document No.:
20220412IP1
Version No.: 3
Owner:
Ian Peerless
Date:
2023-07-25
Page 50 of 69
This document is considered an uncontrolled copy when printed. Always ensure that you print and use a current version.
Copyright 2023 ExRobotics B.V.
▪ Cut the cable tie in this image with a side cutter, be careful not to cut any wires
▪ Using insulated tools, unscrew the cables from the battery terminals in the sequence shown
in the image below. As a precaution, wrap the freed terminals in masking tape to prevent
short circuits.
NOTE: Be cautious when loosening the screws! Improper contact can cause short circuits
and sparks due to high voltages in the batteries.