FIGURE 6 Items in the four-post ush-mount rack kit
1. Front brackets (2)
2. Rear brackets, long (2)
3. Screw, 10-32 x 5/8-in., panhead Phillips (12)
4. Retainer nut, 10-32 (12)
Ensure that the items listed and illustrated in Figure 3 are included in the kit.
CAUTION
Use the screws specied in the procedure. Using longer screws can damage the
device.
Flush-front mounting
CAUTION
The device must be turned o and disconnected from the fabric during this
procedure.
Complete the following tasks to install the device in a four-post rack.
1. Attaching the front brackets on page 27.
2. Installing the device in the rack on page 27.
Four-post rack mount kit installation (XBR-R000297)
ExtremeSwitching SLX 9540 Hardware Installation Guide
26 9036360-00 Rev AB
To Next Page
Loading...
