Extreme Networks ExtremeSwitching SLX 9540 - Verifying Transceiver Operation

Verifying transceiver operation
To verify operation of a transceiver, view the LEDs on the transceiver. To nd the LED locations on the interface modules, refer to LED
activity interpretation on page 73 . After you have connected and congured the ports for Ethernet connectivity and connected the
cable to another active port, the LED becomes solid green. When trac is detected on the port, the light becomes blinking green.
You can also enter the show interface status and show ip interface brief commands to verify proper transceiver operation.
Verifying transceiver operation
ExtremeSwitching SLX 9540 Hardware Installation Guide
9036360-00 Rev AB 71