Extreme Networks ExtremeSwitching SLX 9540 - Installing the Universal Two-Post Rack Kit (XEN-R000294)

FIGURE 9 Attaching the rear brackets to the rack posts
1. Screws, 10-32 x 5/8-in., panhead Phillips 2. Retainer nuts, 10-32
Installing the Universal Two-Post Rack Kit (XEN-
R000294)
Use the following instructions to install an Extreme Networks 1U or 2U device in a two-post telecommunications (Telco) rack using the
Universal Two-Post Rack Kit (XEN-R000294).
There are two ways you can mount the device in a two-post rack:
• With the port side ush with the front posts
• With the posts mounted to the mid-section of the device
Observe the following when mounting this device:
• Two people are required to install the device in a rack. One person should hold the device, while the other screws in the front
and rear brackets
• Before mounting your device, review any specic installation and facility requirements in the Hardware Installation Guide for the
device.
Installing the Universal Two-Post Rack Kit (XEN-R000294)
ExtremeSwitching SLX 9540 Hardware Installation Guide
9036360-00 Rev AB 29