Extron electronics IN1804 Series - Page 20

IN1804 Seamless Scaling Switchers • Installation 12
E
DTP2/XTP input connector (input 4, IN1804 DI and IN1804 DI/DO only) —
Connect a DTP2 transmitter or XTP matrix switcher to this DTP IN RJ-45 connector to
send and receive DTP or XTP signals over a single twisted pair cable (see Twisted Pair
Recommendations for DTP2, XTP, and HDBaseT Communication on page 18 for
wiring and cable recommendations).
The input 4 connector has the following LEDs:
• Signal LED — Lights when the switcher is receiving an active video signal from a
DTP2 transmitter.
• Link LED — Lights when a valid link is established to a DTP transmitter.
ATTENTION:
• Do not connect these ports to a computer or telecommunications network.
• Ne connectez pas ces ports à des données informatiques ou à un réseau de
télécommunications.
• DTP2 remote power is intended for indoor use only. No part of the network that
uses DTP2 remote power should be routed outdoors.
• L’alimentation DTP2 à distance est destiné à une utilisation en intérieur
seulement. Aucune partie du réseau qui utilise l’alimentation DTP2 à distance
ne peut être routée en extérieur.
NOTE: Depending on the connected transmitter, the DTP2 input can travel up to
330 feet (100 meters) without loss of signal integrity.
F
DTP2/XTP/HDBT output connector (output 1A, IN1804 DO and IN1804 DI/DO
only) — The DTP output signal can travel up to 330 feet (100 meters) without a loss of
signal integrity.
Connect a DTP or DTP2 receiver, an XTP matrix, or an HDBaseT-compatible device to
this twisted pair OUT connector. For cable wiring and recommendations, see Twisted
Pair Recommendations for DTP2, XTP, and HDBaseT Communication.
The output 1A connector has the following LEDs:
• Signal LED — Lights when the switcher is sending a signal.
• Link LED — Lights when a valid link is established.
Signal Support
DTP Mode HDBaseT Mode
• HDCP-compliant digital video
• Embedded audio into the TMDS output
or analog audio
• DTP standard IR pass-through signals
on the associated 3-pole captive screw
connector
• Ethernet insertion of RS-232 control
signals
• Remote power to a DTP receiver
• HDCP-compliant digital video
• Embedded audio into the TMDS
output
• IR pass-through signals on the
associated 3-pole captive screw
connector
• Ethernet insertion of RS-232 control
signals