version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 49
Figure 34 Mounting of CGGs
11. Place the CGG’s with tight compression of the gasket on to the manifold!
12. Start with tightening the bolts of the front puller until there is just a small spacing between
manifold and the gas generator (s) (< 1mm).
13. Place the top puller(s) and place and tighten the bolt until the generator (s) touch(es) the
manifold.
14. Re-tighten all bolts at the frontside just enough until there is no visible spacing between
generator(s) and manifold.
15. Place the top clamp(s) on the rear side of the gas generator(s) to secure the gas generator(s) in
the rear cradle.
16. Collect the necessary tools, see Section 4.3.
Figure 35 Squib connection
17. Connect squib cables (you will hear a clicking sound) and press the orange locking buttons on
the squib connectors
18. Place the top cover again and fasten with the screws.
To Next Page
Loading...