Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·100·
RAPIDEN (P130)
It indicates how the rapid movements are carried out. The behavior of this key is managed using
the EXRAPID mark.
The rapid key is treated in execution and simulation as follows:
• The movements are carried out in rapid traverse (G00) while the rapid key is pressed.
• The rapid key is ignored while threading, while look-ahead is active.
• If G95 is active, it switches to G94 mode. When releasing the rapid key, it goes back to G95 mode.
• It only affects the main channel. It is ignored in the PLC channel.
MSGFILE (P131)
Number of the program that contains the OEM texts in several languages.
By default, the CNC sets this parameter to "0" (there is no program).
If programmed with a value of "0", the texts defined by the OEM are in a single language and stored
in several programs:
PLCMSG Texts for PLC messages
PLCERR Texts for PLC errors
The MSGFILE program may be in user memory, in the Memkey card or in the hard disk (KeyCF).
If it is in several places, it takes the one in user memory.
If any of these texts is in Russian or mainland Chinese, the file format must be converted from
Unicode to a special Unicode customized for the Fagor CNC. Use WinDNC to do this conversion.
To display these messages, besides doing this conversion, the CNC must be set in one of the
following languages:
• English.
• Chinese.
• Russian.
FLWEDIFA (P132)
Not being used.
Value Meaning
0 It has no effect.
1 When the mark is activated, the movements are executed in rapid. There
is no need to press the key.
2 The "rapid" key is enabled when the mark is activated or when the key is
pressed. The key must be pressed to make the movements.
Default value: 0
Converting standard Unicode files into Fagor Unicode format requires WinDNC
version 5.1. This conversion is not possible with previous WinDNC versions.
Note: Russian or Chinese comments cannot be displayed in a program even if that program
has been converted using WinDNC.
Having the MSGFILE in the hard disk (KeyCF) requires the memory expansion option.
To Next Page
Loading...
