Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·101·
RETRACAC (P133)
It indicates whether retracing is allowed or not
If RETRACAC = 2, only the M0 is executed; the rest of the M functions are not sent out to the PLC,
it neither executes them nor interrupts the withdrawal. The [CYCLE START] key must be pressed
after executing M0.
Retracing is activated and deactivated with the RETRACE (M5051) signal. This function can also
be activated while function G51 (look-ahead) is active.
If while executing a part program, the PLC sets this signal high, the CNC interrupts the execution
of the program and starts executing backwards what has executed so far.
When the PLC sets the RETRACE signal back low and retracing is canceled. The CNC starts
executing forward what was done backwards and it will go on to execute the part of the program
that was not machined.
G15SUB (P134)
Not being used.
TYPCROSS (P135)
It indicates how cross compensation is applied. This parameter has two digits.
(units) Cross compensation with theoretical or real coordinates.
The units indicate whether cross compensation is applied with theoretical coordinates or with real
ones.
(tens) The cross compensation on Gantry axis affects the slave axis
The tens indicate whether cross compensation on Gantry axes affects only the master axis or both.
AXIS9 (P136) PAXIS9 (P137) AXIS10 (P138)
PAXIS10 (P139) AXIS11 (P140) PAXIS11 (P141)
AXIS12 (P142) PAXIS12 (P143)
If a CNC is configured so that any of the feedback inputs of its axes or spindles is free (because
they are digital axes or spindle without feedback connection to the CNC), these free connectors
could be configured as electronic or mechanical handwheels.
Value Meaning
0 It is not permitted.
1 It is permitted. The withdrawal stops at the M functions.
2 It is permitted. The withdrawal does not stop at the M functions.
Default value: 0
Value Meaning
x0 With real coordinates.
x1 With theoretical coordinates.
Default value: 0
Value Meaning
0x It affects the master axis.
1x It affects both axes.
Default value: 0
To Next Page
Loading...
