Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·108·
ANGAXNA (P171)
Cartesian axis associated with the incline axis.
With the angular transformation of an incline axis, it is possible to make movements along an axis
that is not perpendicular to another. In order to program it in the Cartesian system (Z-X), activate
the incline axis transformation to convert the movements to the non-perpendicular real axes (Z-X').
The axes defined in parameters "ANGAXNA" and "ORTAXNA"must exist and must be linear. Those
axes may have Gantry axes associated with them.
While searching home, the movements are carried out on the incline axes of the machine. PLC mark
"MACHMOVE" determines how the manual movements with handwheels or with the keyboard will
be carried out.
The inclined plane is activated from the part-program (function G46). If the inclined plane is active,
the displayed coordinates will be those of the Cartesian system. Otherwise, it will display the
coordinates of the real axes.
ORTAXNA (P172)
Axis perpendicular to the Cartesian axis associated with the inclined plane.
ANGANTR (P173)
Angle between the Cartesian angle and the angular axis it is associated with. If its value is 0º, there
is no need to do an angular transformation.
Value Meaning Value Meaning
0None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9"C" axis.
Default value: 0 (none)
ANGAXNA X
ORTAXNA Z
ANGANTR 60º
Value Meaning Value Meaning
0None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9"C" axis.
Default value: 0 (none)
To Next Page
Loading...
