Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·110·
Each bit has a function or work mode associated with it. By default, all the bits will be assigned the
value of ·0·. Assigning the value of ·1· activates the corresponding function.
When enabling the additive handwheel, the following must be borne in mind.
• If the DWELL parameter of an axis has been set and it is not previously in motion, it activates
the ENABLE mark of the axis and waits a time period indicated in DWELL to check whether its
SERVOON has been activated or not.
• The acceleration applied to the additive handwheel movement is that of parameter. ACCTIME
of the axis.
• On Gantry axes, the movement of the master axis using an additive handwheel is also applied
to the slave axis.
• The mirror image by PLC is not applied to the additive handwheel movement.
• When testing the software limits during block preparation, it checks the theoretical coordinate
ignoring the additional movement of the additive handwheel.
Bit 11. Selecting the additive handwheel as handwheel associated with the axis.
If this bit is set to 1, even if there is a general handwheel, the additive handwheel will always be the
one associated with the axis.
Bit 12. The resolution of the handwheel is set by g.m.p. ADIMPRES.
This bit indicates whether the handwheel resolution is set by parameter ADIMPRES (bit01) or not.
Otherwise (bit=0), the resolution of the handwheel is set with the switch of the operator panel. If the
switch is not in the handwheel position, it assumes a x1 factor.
Bit 13. Manual intervention enabled with look-ahead.
This bit indicates whether manual intervention is available (bit=1) or not (bit=0) when look-ahead
is active.
Bit 14. Cancel the additive offset after M02, M30, emergency or Reset.
This bit determines (bit=1) that the additive offset is canceled after executing M02/M30 or after an
emergency or reset.
Bit 15. Manual intervention with additive handwheel is available.
This bit indicates whether manual intervention with an additive handwheel is available (bit=1) or not
(bit=0). If set to ·0·, the rest of the bits are ignored.
The additive handwheel is activated and deactivated with PLC signal MANINT.
ADIMPRES (P177)
Resolution of the additive handwheel.
These values are only applied when bit 12 of parameter ADIMPG has been set to ·1·.
Bit Meaning
0 - 10 Not being used.
11 Selecting the additive handwheel as handwheel associated with the axis.
12 The resolution of the handwheel is set by g.m.p. ADIMPRES.
13 Manual intervention enabled with look-ahead.
14 Cancel the additive offset after M02, M30, emergency or Reset.
15 Manual intervention with additive handwheel is available.
Default value in all the bits: 0
Value Meaning
0 0.001 mm or 0.0001 inch.
1 0.01 mm or 0.001 inch.
2 0.1 mm or 0.01 inch.
Default value: 0
To Next Page
Loading...
