Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·111·
SERCDEL1 (P178) SERCDEL2 (P179)
Not being used.
EXPLORER (P180)
It sets how to access the explorer.
REPOSTY (P181)
It may be used to select the repositioning mode:
MAXOFFJ (P182)
This parameter indicates the maximum incremental value allowed for Y axis wear compensation
(it is programmed in mm or in inches). Default value: 0.5.
DISSIMUL (P184)
It may be used to disable the simulation modes and the block search modes when selecting blocks
in execution. Setting the relevant bit to 1 disables it and removes from the menu the softkey assigned
to this bit. This parameter has 16 bits counted from right to left.
For the block search: Disabling in execution:
For simulation: Disabling in simulation:
ACTGAINT (P185)
The axes and the spindle can have 3 sets of gains and accelerations. By default, the CNC always
assumes the first set indicated by the parameters of the axis or of the spindle ACCTIME, PROGAIN,
DERGAIN and FFGAIN.
Parameter ACTGAINT indicates when the CNC assumes the third set of gains and accelerations,
indicated by the parameters of the axis or of the spindle ACCTIMET, PROGAINT, DERGAINT and
FFGAINT.
Value Meaning
0 It is accessed using the < explorer> softkey of the utilities, execute, simulate
or edit modes.
1 It is accessed directly from the utilities, execute, simulate or edit modes.
Default value: 0
Value Meaning
0 It activates the basic repositioning mode
1 It activates the extended repositioning mode
Default value: 1
DISSIMUL = x x x x x x x x 0/1 x x x x x x x
bit 7 = 1 EXEC G SEARCH
bit 6 = 1 EXEC GMST SEARCH
DISSIMUL = 0/1 x x x x x x x x x x x x x x x
bit 10 = 1 RAPID [S0]
bit 11 = 1 RAPID
bit 12 = 1 MAIN PLANE
bit 13 = 1 G, M, S, T FUNCTIONS
bit 14 = 1 G FUNCTIONS
bit 15 = 1 THEORETICAL PATH
To Next Page
Loading...
