Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·112·
This parameter has 16 bits counted from right to left.
Each bit has a function or work mode associated with it. By default, all the bits will be assigned the
value of ·0·. Assigning the value of ·1· activates the corresponding function.
Every time each of the functions or work modes assigned to the bits of g.m.p. ACTGAIN2 (P108)
or ACTGAINT (P185) is activated, the CNC checks the value assigned to the bit corresponding to
that function in these parameters and acts as follows:
• If the bits of ACTGAIN2 is set to ·0· and the bit of ACTGAINT is set to ·0·, it applies the first set
"ACCTIME, PROGAIN, etc".
• If the bit of ACTGAINT2 is set to ·1· and the bit of ACTGAINT is set to ·0·, it applies the third
set "ACCTIME2, PROGAIN2, etc".
• If the bits of ACTGAINT is set to ·1· and the bit of ACTGAIN2 is set to ·0·, it applies the third set
"ACCTIMET, PROGAINT, etc".
When that function or work mode is deactivated, the CNC applies the first of the sets "ACCTIME,
PROGAIN".
Considerations to bear in mind
The change of gains and accelerations is always made at the beginning of the block. When working
in round corner (G5), the change does not take place until G07 is programmed.
The gains and accelerations may also be changed from the PLC. To do that, there is a general logic
CNC input ACTGAINT (M5063). Every time this input is activated, the CNC selects the third set of
gains and accelerations regardless of the active operating mode or function.
Bit Meaning Bit Meaning
0 Threading in blind threads (for
lathe only)
8G51
1G34 9G50
2 10 G49
3G74 11 G48
4JOG 12 G47
5 Rigid tapping 13 G33
6G95 14 G01
7 G75 / G76 15 G00
Default value in all the bits: 0
Example
When setting ACTGAINT = 1000 0000 0001 0000 and ACTGAIN2 = 0000 0000 0000 0000, the
CNC applies the third set to all the axes and the spindle whenever function G0 or the JOG mode
is selected.
Example ·1· Example ·2·
G2 X10 Y10 I10 J0 (Set 1) G05 G2 X10 Y10 I10 J0 (Set 1)
G1 X20 (Set 2) G1 X20 (Set 1)
G3 X30 Y20 I0 J10 (Set 1) G3 X30 Y20 I0 J10 (Set 1)
G1 Y30 (Set 2) G7 G1 Y30 (Set 2)
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
