Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·114·
Blocks affected by the square-corner effect
If bit 0 of g.m.p. MANTFCON (P189) = 1, the CNC will not execute the following blocks in square-
corner mode:
• An F programmed alone in the block.
• Blocks consisting one or more of the following G functions:
G0, G1, G2, G3 (without programaming coordinates)
G5
G6
G10, G11, G12, G13
G32, G94, G95 (when not changing from one to another)
G40, G41, G42, G43, G44
G70, G71
G90, G91
G92 Sxxx
G96, G97 (when not changing from one to another)
G151, G152
Special cases
If Bit 0 of g.m.p. MANTFCON (P189) = 1:
• When executing auxiliary M, S, T functions, the CNC will do it in square-corner mode.
• If a block contains coordinates that coincide with the position of the previous block, the CNC will
not execute it in square-corner mode.
STARTDIS (P190)
When sending an infinite program from a PC to the CNC through Windnc to be executed, there are
the following choices:
1. Once the program has been transmitted, it is executed without pressing any key at the CNC.
2. Once the program has been transmitted, it is not executed until the START key is pressed at
the CNC.
The new general machine parameter STARTDIS (P190) determines whether the program may be
executed or not without pressing START.
This parameter has 16 bits counted from right to left.
Bit 0 of g.m.p. STARTDIS (P190):
Value Meaning
0 The program is sent to the CNC and is executed.
1 The program is sent to the CNC and is not executed until the START key
is pressed.
Default value: 1
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
