Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Axis parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·128·
REFSHIFT (P47)
This parameter is used when once the machine has been all set up, it is necessary to reinstall the
feedback system and the new machine reference point (home) no longer coincides physically with
the previous one.
It indicates the difference existing between the two reference points, the previous one and the current
one.
If this parameter has a value other than 0, once the home search has been carried out (the reference
mark of the feedback device has been detected) , the CNC moves the distance indicated by a.m.p.
REFSHIFT (P47). This way, the machine reference point will always be the same.
This movement is carried out at the feedrate indicated by a.m.p. REFEED2 (P35).
STOPTIME (P48) STOPMOVE (P49)
These parameters are used in conjunction with a.m.p. "STOPAOUT (P50)" with function G52 (move
to hardstop).
STOPTIME (P48)
The CNC considers that the hardstop has been run into when a certain time period elapses without
the axis moving. This time period is indicated, in thousands of a second, by parameter STOPTIME
(P48).
ACFGAIN = NO
ACFGAIN = YES
Possible values
Within ±99999.9999 degrees or millimeters.
Within ±3937.00787 inches.
Default value: 0
Possible values
Integers between 0 and 65535 ms.
Default value: 0
To Next Page
Loading...
