Installation manual
CNC 8035
MACHINE PARAMETERS
Axis parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·127·
MAXFEED (P42)
Indicates the maximum programmable feedrate (F0).
JOGFEED (P43)
Indicates the feedrate F assumed in the JOG mode if no feedrate is active.
PRBFEED (P44)
Indicates the probing feedrate when calibrating a tool in "JOG" mode.
MAXCOUPE (P45)
It indicates the maximum difference allowed between the following errors of the Gantry axes.
This value is only assigned to the slave axis.
ACFGAIN (P46)
Indicates whether or not the value assigned to a.m.p. DERGAIN (P24) is applied onto the variations
of the programmed feedrate (AC-forward).
Possible values
Between 0.0001 and 199999.9999 degrees/min or mm/min.
Between 0.00001 and 7874.01574 inches/min.
Default value: 5000 mm/min.
Possible values
Between 0.0001 and 199999.9999 degrees/min or mm/min.
Between 0.00001 and 7874.01574 inches/min.
Default value: 1000 mm/min.
Possible values
Between 0.0001 and 99999.9999 degrees/min or mm/min.
Between 0.00001 inches/min and 3937.00787 inches/min.
Default value: 100 mm/min.
Possible values
Between 0.0001 and 99999.9999 degrees or millimeters.
Between 0.00001 and 3937.00787 inches.
Default value: 1 mm.
Value Meaning
NO It is applied on variations of following error (derivative gain).
YES It is applied on the variations of the programmed feedrate that are due to
acceleration/deceleration (AC-forward).
Default value: YES
To Next Page
Loading...
