Installation manual
CNC 8035
MACHINE PARAMETERS
General machine parameters
4.
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·83·
NPOCKET (P24)
Indicates the number of pockets in the tool magazine. On the other hand, the CNC adjusts the length
of the tool magazine table to that value.
RANDOMTC (P25)
Indicates whether the tool magazine is random or not.
• On a random magazine, the tools may occupy any position (pocket). If this machine parameter
is set for random magazine, g.m.p. TOFFM06 (P28) must be set for machining center.
• On a non-random magazine, the tool always occupies its own pocket. The magazine position
number is the same as the tool number.
In a non-random magazine, the tools must be placed in the tool magazine table in the pre-established
order (P1 T1, P2 T2, P3 T3, etc.). Optionally, g.m.p. TOOLMATY (P164) may be used to assign
several different tools to each tool position. In this case, the magazine position number may be
different from the tool number.
TOOLMONI (P26)
Selects the display units of the tool’s nominal and real lives.
NTOFFSET (P27)
Indicates the number of tool offsets available in the tool offset table. On the other hand, the CNC
adjusts the length of the tool offset magazine table to that value.
TOFFM06 (P28)
Indicates if the machine is a machining center.
If it is, the CNC will select, at the tool magazine, the tool indicated when executing the "T" function
and it will be necessary to execute M06 afterwards in order to carry out the tool change.
It is recommended to associate he subroutine corresponding to the tool changer with the M06.
Possible values
Integer numbers between 0 and 255.
Default value: 100 (for the M model)
Default value: 0 (for the T model)
Value Meaning
YES It is a random tool magazine.
NO It is not a random tool magazine.
Default value: NO
Value Meaning
0 Tool life in minutes
1 Tool life in number of operations.
Default value: 0
Possible values
Integer numbers between 0 and 255.
Default value: 100
Value Meaning
YES Yes, it is a machining center.
NO It is not a machining center.
Default value: NO
To Next Page
Loading...
