Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·84·
NMISCFUN (P29)
Indicates the number of M functions available in the M function table.
MINAENDW (P30)
Indicates the minimum time period that the AUXEND signal must remain activated so the CNC will
interpret it as a valid signal. AUXEND is a PLC signal which indicates to the CNC that functions M,S
or T have been executed.
If the corresponding M function has been set in the M table not to wait for the AUXEND signal, the
time period indicated in this parameter will be the duration of the MSTROBE signal.
See "5.8 Auxiliary M, S, T function transfer" on page 221.
NPCROSS (P31)
Indicates the number of points available in the first cross compensation table.
This compensation is used when the movement of one axis causes a position change on another
axis. The CNC offers a table where one could enter the position variations of one axis for the
particular positions of the other axis.
MOVAXIS (P32)
Used in the first cross compensation table, it indicates the axis causing position variations on another
axis. The definition code is:
COMPAXIS (P33)
Used in the first cross compensation table, it indicates the axis suffering the position variations
caused by another axis. The compensation is applied onto this axis. The definition code is:
Possible values
Integer numbers between 0 and 255.
Default value: 32
Possible values
Integers between 0 and 65535 ms.
Default value: 100
Possible values
Integer numbers between 0 and 255.
Default value: 0 (not available)
Value Meaning Value Meaning
0None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9"C" axis.
Default value: 0 (none)
Value Meaning Value Meaning
0None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9"C" axis.
Default value: 0 (none)
To Next Page
Loading...
