Installation manual
CNC 8035
4.
MACHINE PARAMETERS
General machine parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·94·
MPG1CHG (P83) MPG1RES (P84) MPG1NPUL (P85) MPG2CHG (P86)
MPG2RES (P87) MPG2NPUL (P88) MPG3CHG (P89) MPG3RES (P90)
MPG3NPUL (P91)
These parameters must be used when the machine has several electronic handwheels, one per axis.
Set the a.m.p. for the feedback input of the electronic handwheel AXIS1 (P0) through AXIS7 (P6),
to one of the following values:
Parameters "MPG1***" correspond to the first handwheel, "MPG2***" to the second one and
"MPG3***" to the third one.
The CNC uses the following order to know which one is the first, second and third handwheel: X,
Y, Z, U, V, W, A, B, C.
The meaning of parameters MPG*CHG, MPG*RES and MPG*NPUL is similar to the meaning of
parameters MPGCHG (P80), MPGRES (P81) and MPGNPUL (P82).
CUSTOMTY (P92)
It indicates the configuration being used.
Keyboard auto-identification
The keyboard has an auto-identification system that updates this parameter automatically.
Value Meaning Value Meaning
21 Handwheel associated with X. 26 Handwheel associated with W.
22 Handwheel associated with Y. 27 Handwheel associated with A.
23 Handwheel associated with Z. 28 Handwheel associated with B.
24 Handwheel associated with U. 29 Handwheel associated with C.
25 Handwheel associated with V.
Possible values
250.
Default value: 0
The auto-identification system of the keyboards is recognized from versions V9.11
and V10.11 on.
If an auto-identifying keyboard is connected to a CNC that has an older software
version, the keyboard will beep. In this case, disable the auto-identification hardware
of the keyboard by setting the identification switch to zero.
To Next Page
Loading...
